Differences

This shows you the differences between two versions of the page.

--- documents:de4000:de4000operate [2022/02/02 20:26]
admin
+++ documents:de4000:de4000operate [2022/02/02 21:08] (current)
admin
@@ Line 71: / Line 71: @@
 ==== - Select the Input Channel to be configured ====
- Click on the INX box and select IN1.
+ Click on the INx box and select IN1.
 {{ :documents:de4000:inch.jpg?nolink}}
 ==== - Configure Input Channel 1 ====
@@ Line 100: / Line 100: @@
 Use the same procedure as above to configure Channel
 , Terminal 1.
- Click on >CHAN (in the channel navigation bar) or click on INX to access
+ Click on >CHAN (in the channel navigation bar) or click on INx to access
 Channel 2.
 A. Set Channel 2 as a Thermocouple input.
@@ Line 145: / Line 145: @@
 ==== - Configure an RPM Channel ====
-Click on the INX box, a dropdown will appear
+Click on the INx box, a dropdown will appear
 that contains all of the 32 inputs, DO1-DO8 Discrete Outputs, AO1-AO4 Analog
 Outputs, and RPM Inputs. See Figure 3.17.
@@ Line 1275: / Line 1275: @@
 they cannot be changed because of the security level.
-==== - Terminal - X ====
+==== - Terminal x ====
 Use the Terminal selection dropdown box to select a Terminal
 Module{{ :documents:de4000:termselect.jpg?nolink|}} to configure. Note that only the Terminal Modules configured in the
@@ Line 1283: / Line 1283: @@
 \\
-==== - INX ====
+==== - INx ====
 Use the I/O selection dropdown page to select inputs and outputs to
-configure. Clicking on the INX selection box presents all of the I/O channels on
+configure. Clicking on the INx selection box presents all of the I/O channels on
 the selected Terminal Module. Select a channel to configure.