Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
documents:afr-500:afr500operating [2023/03/09 11:13] rocky [9.1 POWER WIRING] |
documents:afr-500:afr500operating [2023/03/22 13:38] (current) rocky [3.3 Interface options] |
||
|---|---|---|---|
| Line 28: | Line 28: | ||
| As an AFR system the AFR-500 offers the ability to be used as a single device or one unit per bank on a " | As an AFR system the AFR-500 offers the ability to be used as a single device or one unit per bank on a " | ||
| + | ===== - UPDATING FIRMWARE ===== | ||
| + | Follow this link to our [[https:// | ||
| ===== - Connecting to The System ===== | ===== - Connecting to The System ===== | ||
| Line 53: | Line 55: | ||
| < | < | ||
| - | Click here for <font size=" | + | Click here for <font size=" |
| </ | </ | ||
| Line 327: | Line 329: | ||
| Input power supply wires (16 AWG minimum) should connect to the +24 volt and | Input power supply wires (16 AWG minimum) should connect to the +24 volt and | ||
| GND supply terminals of the main terminal block. | GND supply terminals of the main terminal block. | ||
| + | ==== - STEPPER VALVE WIRING ==== | ||
| Using the 693013-x cable connected to the stepper motor routes it to the dual | Using the 693013-x cable connected to the stepper motor routes it to the dual | ||
| Line 344: | Line 347: | ||
| \\ | \\ | ||
| \\ | \\ | ||
| + | ==== - LAMBDA SENSOR LSU 4.9 WIRING ==== | ||
| The Lambda sensor is connected via shielded cable P/N 693226-1. This should | The Lambda sensor is connected via shielded cable P/N 693226-1. This should | ||
| be run in conduit only with the AFR-500 thermocouple connections. These cables | be run in conduit only with the AFR-500 thermocouple connections. These cables | ||
| Line 546: | Line 550: | ||
| * Non-latching registers that when mapped to the AWI appear as an LED and turn off after the fault condition has cleared | * Non-latching registers that when mapped to the AWI appear as an LED and turn off after the fault condition has cleared | ||
| * Latching registers that when mapped to the AWI will appear as an LED and stay on even after the thermocouple is no longer in the fault condition | * Latching registers that when mapped to the AWI will appear as an LED and stay on even after the thermocouple is no longer in the fault condition | ||
| - | * A digital output signal attached to Digital Output 1 that latches on a fault condition | + | * A digital output signal attached to LS Digital Output 1 that latches on a fault condition |
| To clear all of the alarms, regardless of a single or dual bank system, there is one ALARM ACKNOWLEDGE register. | To clear all of the alarms, regardless of a single or dual bank system, there is one ALARM ACKNOWLEDGE register. | ||